PEERLESS ONEMount ONE-TP Instalación Y Ensamblaje página 7

With tape measure, measure the outside to outside of the brackets on the back of your screen. If width of the tilt
3
brackets on back of the screen is over 18-1/2" shown in figure 3.1, using a 7/16" wrench, attach wing bracket (GG)
to center bracket using two 1/4" serrated flanged locknuts (FF) as shown in figure 3.2. If width of the brackets on
back of the screen is over 30-3/8", using a 7/16" wrench, attach second wing bracket (GG) to center bracket using
two 1/4" serrated flanged locknut (FF) as shown in figure 3.3.
CAUTION: If mounting to two studs on 16" centers, and using the three plate configuration, A STUD
MUST BE SKIPPED in the middle so distance between studs is 32".
AA
18.5"
FF
AA
GG
fig. 3.1
fig. 3.2
AA
GG
FF
fig. 3.3
7 of 33
ISSUED: 09-20-06 SHEET #: 202-9167-4 11-13-07