Aircare EP9 Serie Manual De Instrucciones página 3

3
2
Remove everything from the base.
Turn the base over and insert the
casters snugly into the bottom. Just use your
hands! Using tools can crack the base.
3
Remove the float from the back of the
wick frame. Place the wide end of the
float in the circular area in the base. Slide the
float retainer down to the base and squeeze
gently to seat the screw tabs between the
pegs. Use a Phillips screwdriver to screw in the
float retainer. Do not overtighten or use a drill.
4
Put your Pedestal base in the most
centrally-located room of your home.
It should be on a level surface against an
interior wall. Make sure it's at least two inches
from the wall so the humidistat (on the cord)
can accurately read your humidity.
More about positioning:
• To maximize humidity circulation, put your unit near a cold air return.
• If you prefer to put your unit in the room where humidity is most
needed, you can! But the humidity won't circulate as well with this
method.
• Don't put your humidifier under a window, as condensation may
occur.
• Put the unit on the bottom floor of a multi-story home.
5
With the wick in the frame, place the
frame into the base with the MAX
FILL label facing the base's FRONT label. Fill
the base with water. Your Pedestal holds 3.5
gallons of water.
About water additives:
• Do not use essential oils in your Pedestal.
• Do not use water softeners.
• We recommend our Essick Air Bacteriostat to help inhibit
mold growth.
Note: For future refills, you can either remove the top and fill
the base, or use the funnel. To use the funnel, simply slide the
pronged end of the funnel into the fill door.
6
Put the top on the base. Make sure
the top of the float rod makes a solid
connection with the fan switch inside the fan
assembly. This looks like a small, silver diving
board.
7
Wait 20 minutes for the filter to become
fully saturated, then proceed to step 8.
4