Main Characteristics; Technical Characteristics - Whirlpool AGS 266/WP Instrucciones Para La Instalación, El Uso Y El Mantenimiento

Fregadero las patas
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN

4- MAIN CHARACTERISTICS

DESCRIPTION OF EQUIPMENT
This handbook concerns various equipment
models.
For further information regarding your model,
please refer to the "Technical Data" table.
_Range of single or double-opening ambient and
hot cupboard counters with sliding or leaf doors.
_Range of equipped cupboard counters with
sliding or leaf doors.
_Range of sinks with sliding-door cupboards.
_Range of
sinks
with
cupboards for inserting a dishwasher.
_Range of sliding-door crockery storage cabinets.
Information on noise levels:
The functional components of the equipment in
question have a noise level not exceeding 70
dB(A).

TECHNICAL CHARACTERISTICS

The declared max. load capacity of the equipment
is 100kg per shelf.
Power supply 220-240/1/50-60Hz.
Consumption 2.4 kW.
The "hot" units come with telethermostat preset to
50°C with a worktemperature range 50°C
PERFORMANCE HOT CUPBOARD
HOT CUPBOARD TYPE
TEMP. OFFSET
TEMPERATURE OF DISH (T "average" = °c with maximum load)
Dimensions
pre-adjust 50°c
60 min.
(mm.)
range (°c)
1 H
L1000xP700xH850-900
50-60
32-36
L1200xP700xH850-900
50-60
31-35
L1400xP700xH850-900
50-60
30-34
L1600xP700xH850-900
50-60
29-33
L1800xP700xH850-900
50-60
28-32
L2000xP700xH850-900
27-31
50-60
EQUIPMENT IDENTIFICATION
The equipment model is given in the PNC field on
the "Technical Data" plate located on the inside of
the cupboard.
GENERAL INSTRUCTIONS
Before installing and starting the equipment,
carefully read this handbook as it provides
important information and instructions on safe
installation, use and maintenance.
Carefully keep this handbook for further
consultation by the various operators, or in case
the equipment is resold.
Important:
Equipment installation and any maintenance
work or adaptation must only be carried out by
sliding
or
leaf-door
÷
60°C.
NUMBER OF DISH (approx.)
90 min.
120 min.
150 min.
180 min.
shelf
1,5 H
2 H
2,5 H
3 H
Ø235 mm. Ø255 mm. n.
37-43
41-49
44-53
46-56
96
36-42
40-48
43-52
45-55
128
35-41
39-47
42-51
44-54
160
34-40
38-46
42-50
44-53
160
33-39
37-45
41-49
43-52
192
32-38
36-44
40-48
42-51
224
professionally qualified personnel authorised
by the Manufacturer.
This equipment is intended for specific industrial
use; any other type of use is deemed improper.
It must only be used by trained personnel.
Always switch the equipment off in case of a fault
or poor operation.
For any repairs, contact only a technical
assistance centre authorised by the
manufacturer and demand original
replacement parts.
Failure to observe the above can compromise
the equipment's safety and invalidates any
form of warranty.
Do not wash the equipment with direct jets of
water.
Do not use products containing chlorine (sodium
hypochlorite, hydrochloric acid, etc.), even if
diluted, to clean the steel.
Do not use corrosive substances (e.g. muriatic
acid) to clean the floor under the equipment.
The manufacturer declines any liability for
operations carried out on the equipment
without following the instructions given in the
manual.
No part of this manual can be reproduced.
WASTE DISPOSAL AND SCRAPPING
At the end of the product's working life, make sure
it is not dispersed in the environment.
Special waste can be stored temporarily awaiting
disposal by treatment and/or permanent storage.
In any case, the current environmental protection
laws in the country of use must be observed.
Different regulations are in force in the various
countries, therefore the provisions of the laws and
competent bodies in the countries where
demolition takes place must be observed.
In general, the equipment must be taken to a
bottom total
specialised collection/demolition centre.
102
198
Dismantle the equipment, grouping the parts
136
264
according to their chemical characteristics,
136
296
remembering that some can be recovered and
170
330
204
396
reused and that in any case it concerns waste
238
462
assimilable with urban waste.
Make the equipment unusable before disposal,
removing the power cable and any compartment
closing device, to prevent the possibility of
someone becoming trapped inside.
The symbol
indicates that it should not be considered as
domestic waste, but must be correctly disposed of
in order to prevent any negative consequences for
the environment and the health of people.
For further information regarding the recycling of
this product, contact the agent or local dealer, the
after-sales service or the local body responsible
for waste disposal.
Dismantling operations must be carried out by
qualified personnel.
13
"WEEE" on the product

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ags 261/wpAgs 304/wp

Tabla de contenido