Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Figure 4
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
1.
Exhaust tips removal - use T40 driver to remove (2) bolts from tips bottom each side. Use 10mm socket to remove (1) bolt each side which secures the exhaust hanger bracket and lower down the muffler.
2.
Taillight removal - remove (1) plastic wing nut inside the trunk each side and then unplug the wiring, see Figure 2.
3.
Heat shield removal - use 8mm socket to remove (6) flange nuts which secure heat shield and rest the heat shield on muffler. Do not take the heat shield out of the vehicle.
4.
Bumper fascia removal - use 10mm socket and flat screwdriver to remove (2) plastic rivets, (2) bolts at rear fascia bottom per side (see Figure 3), and (1) plastic rivet, (1) bolt at rear wheel well trim panel
per side (see Figure 3). Gently pull off the rear wheel well trim panel each side by unclipping the tabs inside, see Figure 4. Gently remove the fascia by pressing the vertical tabs along inside top section of
fascia and unplugging wiring each side. Set bumper fascia aside.
5.
Bumper beam removal - use 16mm socket to remove (4) flange nuts inside bumper panel each side. Unclip the wiring attaching on bumper beam passenger side and take the bumper down.
6.
Hitch installation - align the holes in hitch with the welded bolts on bumper beam. Raise the hitch/bumper together and place them through original bumper mounting holes. Loosely fasten the nuts.
7.
Heat shield trimming - locate the center of heat shield and trim 2'' tall and 4.5''wide area, see Figure 5. Make additional trimming if needed.
8.
Tighten all fasteners with torque wrench to 38 Lb.-Ft. (52 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
9.
For sport model, make slight trimming on the rear fascia bottom if necessary. Reinstall the heat shield, fascia, and exhaust removed in step 1 - 4.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 75223, 87690, 44777
NOTE: For "SPORT MODEL" slight lower
fascia trimming is necessary.
Vehicle end panel
Bumper beam
Rear
Figure 1
Fastener Kit: 75223F
Sheet 3 of 15
Figure 2
Figure 3
2''
4.5''
Figure 5
75223NP
06-30-15
Rev. A
Publicidad
