Cequent Performance Products 75223 Instrucciones De Instalación página 4

1. Exhaust tips removal - use T40 driver to remove (2) bolts from tips bottom each side. Use 10mm
socket to remove (1) bolt each side which secures the exhaust hanger bracket and lower down the
muffler.
4. Bumper fascia removal - use 10mm socket and flat screwdriver to remove (2) plastic rivets, (2)
bolts at rear fascia bottom per side (see Figure 3), and (1) plastic rivet, (1) bolt at rear wheel well
trim panel per side (see Figure 3). Gently pull off the rear wheel well trim panel each side by
unclipping the tabs inside, see Figure 4. Gently remove the fascia by pressing the vertical tabs
along inside top section of fascia and unplugging wiring each side. Set bumper fascia aside.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Taillight removal - remove (1) plastic wing nut inside the trunk each side and then unplug the
wiring, see Figure 2.
3. Heat shield removal - use 8mm socket to remove (6) flange nuts which secure heat shield and
rest the heat shield on muffler. Do not take the heat shield out of the vehicle.
5. Bumper beam removal - use 16mm socket to remove (4) flange nuts inside bumper panel each
side. Unclip the wiring attaching on bumper beam passenger side and take the bumper down.
Sheet 4 of 15 75223NP 06-30-15 Rev. A