Publicidad
12
12
Adjusting screw
(horizontal)
(vertical adjustment)
Refer to the enlarged diagram to identify the parts on the HINGES and HINGE BRACKETS.
The DOOR may need some adjustments. Follow the text below to make needed adjustments.
DOOR ADJUSTMENTS:
To adjust the DOOR from side to side (horizontal), loosen the mounting screw several turns, then turn the adjusting screw in or out.
Tighten the mounting screw after making adjustments.
To adjust the DOOR up and down (vertical), loosen both screws that fasten the HINGE BRACKETS to the END. Move the DOOR
up or down to the desired location. Tighten the screws after making adjustments.
To adjust the DOOR in or out (depth), loosen the mounting screw one turn and move the DOOR in or out, as needed. Tighten the
mounting screw after making adjustments.
402375
Mounting screw
(depth))
www.sauder.com/services
Page 17
Publicidad
