Hansgrohe Talis S 06462 Serie Instrucciones De Instalación página 6

English
Install the handspray hose: slide the nut, cone
washer, brass washer and black rubber washer over the
end of the connecting hose.
Begin tightening by hand, then finish by using a wrench.
Hold the handspray hose steady
while tightening the nut. Do not
allow either hose to twist.
Connect the supply hoses to the stops.
Use two wrenches, as shown
in the diagram, to prevent the
hoses from twisting.
Install the hose weight: proper positioning of the hose weight
insures that the hose will retract smoothly.
Install the hose weight on the handspray hose.
Pull out on the handspray and guide it back into the holder.
Reposition the weight if necessary.
Turn on the water and check all connections for leaks.