Step 1 Connecting Devices; Preparing The Devices To Use; Connecting The Usb Cable - Sony IPELA RM-NS1000 Guía De Inicio

Step 1 Connecting Devices

Decide where to install the system controller and then connect the devices to be used to the
controller.

Preparing the Devices to Use

Prepare the devices to be connected to and used with the system controller according to the
application.
• USB keyboard
• USB mouse
• Headphones (can only be used with RealShot Manager Advanced)
• Microphone (can only be used with RealShot Manager Advanced)
• Pelco-D or -P protocol camera (for use in Pelco mode)
Note
A keyboard and mouse are required when logging on to the NSR-1000 series or RealShot
Manager Advanced.

Connecting the USB Cable

Use the USB cable to connect the system controller to the computer on which NSR-1000
series or RealShot Manager Advanced is installed.
1
Thread the USB cable through the groove underneath the controller in accordance with
the location that the system controller is placed.
USB Cable
Step 1 Connecting Devices 9