Troubleshooting - Insignia IS-HTIB102731 Manual Del Propietário

Troubleshooting

If you experience any of the following difficulties
while using the system, use this troubleshooting
guide to help you remedy the problem. Should
any problem persist, consult your nearest service
center.
No power.
Is the power cord firmly plugged into the power
outlet?
One of the safety mechanisms may be operat-
ing. In this event, unplug the player from the
power outlet briefly and then plug it in again.
No picture.
Check that the system is connected securely.
The video connecting cord is damaged. Re-
place it with a new one.
Make sure you connect the system to video
input connector on the TV.
Make sure you turn on the TV.
Make sure you select the video input on the TV
so that you can view the pictures from this sys-
tem.
The picture noise appears.
Clean the disc.
If video from this system has to go through your
VCR to get to your TV, the copy-protection
applied to some DVD programs could affect pic-
ture quality. If you still experience problems
after checking your connections, please try con-
necting your DVD system directly to your TV's
S-Video input, if your TV is equipped with this
input.
The aspect ratio of the screen cannot be
changed even though you set "TV
DISPLAY" in the SETUP menu when you play
a wide picture.
The aspect rate is fixed on your DVD disc.
If you connect the system with the S-Video
cable, connect directly to the TV. Otherwise,
you may not change the aspect ratio.
Depending on the TV, you may not change
the aspect ratio.
There is no sound or only a very low-level
sound is heard.
Check that the speakers and components are
connected securely.
Make sure that you have selected the correct
source on the system.
The protective device on the system has been
activated because of a short circuit. Turn off
the system, eliminate the short-circuit problem
and turn on the power again.
The audio connecting cord is damaged. Re-
place it with a new one.
The system is in pause mode or in slow-motion
play mode, or fast forward or fast reverse is
performed. Press
mode.
Check the speaker settings.
The left and right sounds are unbalanced
or reversed.
Check that the speakers and components are
connected correctly and securely.
Adjust front balance parameter using SELECT
and VOLUME (- or +) buttons .
Severe hum or noise is heard.
Check that the speakers and components are
connected securely.
Check that the connecting cords are away from
a transformer or motor, and at least 3 meters
away from a TV set or fluorescent light.
Move your TV away from the audio compo-
nents.
The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.
Clean the disc.
The sound loses stereo effect when you
play a CD.
Set the Audio mode to "STEREO" in the
SETUP menu.
Make sure you connect the system appropri-
ately.
Radio stations cannot be tuned in.
Check that the antennas are connected cor-
rectly. Adjust the antennas and connect an ex-
ternal antenna if necessary.
The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
No stations have been preset.
The remote does not function.
Remove any obstacles between the remote
control and the system.
Use the remote control near the system.
Point the remote control at the remote sensor
on the front panel.
Replace all the batteries in the remote con-
trol with new one if they are weak.
Check that the batteries are loaded correctly.
ll to return to normal play
27