Kit Assembly - Metra 99-8161S Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the brackets to the radio
trim panel (without factory door)
using the (4) #8 x 3/8" Phillips
screws. (Figure A)
2. Mount the pocket to the
bracket/panel assembly with the
(4) #8 x 3/8" Phillips screws
supplied. (Figure B)
3. Slide the radio into the assembly
and secure with screws supplied
with the radio. (Figure C)
4. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
5. Mount the new radio assembly into
the dash and reassemble the dash
in reverse order of disassembly.

Kit Assembly

(Figure A)
99-8161S
(without factory door)
(Figure B)
3
(Figure C)