English - Philips HR8353/01 Manual De Instrucciones

English

• To enable recycling, the plastics of
the product have been coded.
• The cardboard packaging has
been made of recycled material
and is entirely suitable for recycling.
Important
• Before using for the first time, check if
the dustbag is placed correctly.
• Never suck up water (or any other
liquid). Never pick up ashes until they
are cold.
• When picking up fine dust, the pores of
the dustbag may become clogged.
This will obstruct the air passage.
Subsequently, the dustbag needs
replacement, although the bag might be
far from full.
• Avoid damage. Never use the vacuum
cleaner without the motor protection
filter.
• Only use Philips s-bag™double-layer
paper dustbags (FC 8021) or Philips
Sydney+ double-layer paper dustbags
(type HR 6999 Sydney+).
• If the mains cord of this appliance is
damaged, it must only be replaced by
Philips or their service representative, as
special tools and/or parts are required.
Please note that * in the illustration numbers
(page 3) means: this illustration applies to special
models only.
How to use
- Connecting the hose: push in and rotate
clockwise (fig. 1a, 1b).
- To disconnect: rotate anti-clockwise (fig. 2).
- Connecting the tubes to the handgrip: fig. 3.
- Adjusting the combi nozzle:
to carpets (fig. 4) or to hard floors (fig. 5).
- Adjusting the suction power: fig. 6, 7, 8.
Insufficient suction power?
Please check:
- if the dustbag is full;
- if the nozzle, tube or hose is blocked up.
To remove the obstruction, let the air stream in
opposite direction through the hose and/or
tube.
f
Park
If you wish to interrupt vacuum cleaning, you can
place the tube clip into the rest (fig. 9).
You can slide the clip along the tube to change
the height.
In one movement the tube is parked in a
convenient position (fig. 10).
Storage
- Hitch the lower tube onto the vacuum cleaner
(fig. 11, 12). You can slide the clip along the
tube to change the height.
Replacing the dustbag
The "dustbag full indicator" will indicate when the
dustbag is full (fig. 13).
- Open the cover (fig. 14).
- Push the dustbag holder backwards (fig. 15).
- Remove the full dustbag by pulling the
cardboard tag (fig. 16).
This automatically closes the dustbag.
- Slide the cardboard front plate of the new
dustbag into the two slots of the dustbag holder
as far as possible (fig. 17).
- Push the dustbag holder forwards ("Click!")
(fig. 18).
Note that it is not possible to close the cover
when no dustbag has been placed.
Dustbags
• Philips s-bag™ paper dustbags are available
under type number FC 8021.
Please refer to the type number.
• A new motor protection filter and an AFS
Micro filter are provided free with each set of
dustbags.
4