Philips HR8353/01 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
The motor protection filter
Your appliance has been equipped with a greatly
improved, triple permanent motor protection filter.
This filter ensures an optimal protection of the
motor. This filter does not need to be replaced.
This means that you can simply throw away the
replacement filter that is supplied with the
dustbags, since this filter is only required for older
versions of this vacuum cleaner.
All you have to do is shake out the permanent
filter and reinsert it into the vacuum cleaner every
time you put in a new dustbag (fig. 19-21).
- Position the filter in the holder as it was
previously placed and press it firmly.
- Push the holder with the clean filter into its
place so that the filter fits correctly at the
bottom.
Replacing the AFS-Micro filter
The indicator will help you determine if the AFS-
Micro filter needs replacing (fig. 22-24).
- Position the lower edge of the new filter
properly behind the ridges of the holder
(fig. 23).
- When closing the holder, ensure that the filter
fits in completely (fig. 24).
Obtaining dustbags / filters
In case you have any difficulties obtaining
dustbags or accessories for this vacuum cleaner,
please either phone 01480 493 000 or write to:
MPP Marketing Ltd., P.O. Box 40, St. Ives,
Huntingdon, Cambridgeshire. PE17 4XS.
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp.
plug.
Should you need to replace the plug, connect the
wires as follows:
Brown wire to the Live (L) terminal of the new
plug.
Blue wire to the Neutral (N) terminal of the new
plug.
Always fit the same value of fuse as that originally
supplied with your appliance. For your appliance
this should be a 13 Amp. fuse (brown).
Only use BS 1362 approved fuses.
When disposing of an old plug (particularly the
moulded type which has been cut from the mains
cord) always remove the fuse as the plug could
be dangerous if ever inserted in a live socket.
If your vacuum cleaner is equipped with a
cord winder:
Before cutting the plug off, temporarily tie a knot
in the mains cord to prevent it being inadvertantly
drown into the cordwinder.
After fitting the new plug, untie this knot.
5
For U.K. only:

Publicidad

Tabla de contenido
loading

Tabla de contenido