Installation Using The Screw Holes On The Side Of The Unit - Pioneer FH-P5000MP Manual De Instalación

Installation
Note:
• Before finally installing the unit, connect the • If installation angle exceeds 30° from horizontal,
wiring temporarily, making sure it is all connected the unit might not give its optimum performance.
up properly, and the unit and the system work (Fig. 3)
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
30˚
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the driver's
way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
• When installing, to ensure proper heat dispersal
— for instance, near a heater outlet.
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.

Installation using the screw holes on the side of the unit

Fastening the unit to the factory radio mounting bracket. (Fig. 4) (Fig. 5)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fit-
ted), and tighten the screws at 3 or 4 places on each side.
Use either truss screws (5 × 8 mm) or flush surface screws
(5 × 8 mm), depending on the shape of the screw holes in
.
the bracket
Fig. 3
Screw
Be sure to use the screws
supplied with this product.
Factory radio mounting bracket
<ENGLISH>
Fig. 4
If the pawl gets in the
way, bend it down.
Dashboard or Console
Fig. 5