FITFIU FITNESS RA-200 Manual Usuario página 32

ASSEMBLY
STEP 1
Remove the two M8x65 bolts (66), the two curved 22
washers (21) and the two M8 nuts (22) from the front
21
stabiliser (3).
Position the front stabiliser on the main frame (1)
3
1
and secure it with the two M8x65 bolts (66), the two
curved washers (21) and the two M8 nuts (22).
Tighten and secure them with a spanner and the
66
supplied crosshead screwdriver.
56
57
58
STEP 2
2
Insert the seat cushion (64) into the rail (2), and then
58
install two Ø23×15 bearings (58), two Ø5×Ø9×1.0 flat
64
57
washers (57) and two ST4.2×25 flat head screws (56)
56
into the rail (2).
Install two rubber pads Ø38×M10 (49) on the rear
4
18
bracket stabiliser (4). Then fix the rear bracket stabiliser
59
(4) on the rail (2) with three M8×15 hex screws (59) and
three flat washers Ø8×Ø16×1,5 (18).
49
Tighten the screws with the Allen key provided.
49
72
STEP 3
Connect the rail (2) to the main frame rail joint (1) with
53
an M10×105 hex bolt (53), a Ø10×Ø20×2.0 flat washer
33
(55) and an M10 nylon nut (54). Insert the Ø10×98 pin
1
(33) to lock the rail (2) in place.
72
Connect the sensor cable (36) and the extension
sensor cable (72).
55
54
36
2
32