Replacement Filter Assembly; Important - RIDGID WD7000 Manual Del Operador

SP6659-3 WD7000 ES.qxd

Replacement Filter Assembly

NOTE: The filter is accessed by
unlatching and removing the dust drum.
The filter support assembly can be
removed by grasping the filter support as
shown in the illustrations below.
TC AR T
SM AR
Filter Support
Assembly
Dust
Drum
1. Carefully slide the filter over the center
ring until the filter stops against the
filter support.
2. Place the filter plate and the filter nut
onto the threaded stud and tighten it
down. Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter plate,
center ring or filter.
3/26/08 9:44 AM Page 7
Filter Nut
Lever
Latch (2)
Pull Down and
Slide Dust Drum
Out of Wet/Dry
Vac Unit
!
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac
with any parts damaged or missing.
!
personal injury or damage to vac be
sure to keep hands, fingers, or any
other foreign objects out of the
center opening when assembling
the float.
7
THIS SIDE
TOWARDS LID
WARNING: For your own safety,
WARNING: To reduce the risk of
Filter Nut
Filter Plate
Filter
Center Ring
Open End
of Float
Filter
Support