Setting Up The Refrigerator; Components For Handle Assembly; How To Assemble The Handle - Samsung RF266 Manual De Usuario

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and
functions of the appliance.
By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions in
this manual.
2. Once the Refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer will
get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator once
the temperature is sufficiently cool.
Check the accessory list below.

COMPONENTS FOR HANDLE ASSEMBLY

[ 3-DOOR TYPE ]

HOW TO ASSEMBLE THE HANDLE

Fridge door handle assembly
OK OK
To best conceal the connection
points : Assemble the handles
with the mounting screws facing
each other.
Hex wrench
(DA80-00002C)
Water filter
(DA29-00003B)
Fastener
(DA60-00143B)
Fridge
Freezer
the screw and then put the handle
By using L-wrench, Fix the screw with the Longer part of it and
then fully tighten up with the Shorter part.
Compression Compression
fitting nut
(DA62-00305A) (DA74-00070B)
Washer
(DA80-00002C)
(Optional)
Setting Up _9