Setting Up The Refrigerator; Installing The Handles - Samsung RS25H50 Serie Manual Del Usuario

Flooring
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring during
installation, cut a large section of the cardboard
carton and place it under the refrigerator where
you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
When installing, servicing or cleaning
behind the refrigerator, be sure to pull the
CAUTION
unit straight out and push back in straight
after finishing.
Important: Make sure that you can easily move
your refrigerator to its final location by measuring
doorways (both width and height), thresholds,
ceilings, stairways, etc.
The following chart details the exact height and
depth of this Samsung Side by Side Refrigerator.
DA68-02981F (EN)-150612.indd 17
Dimensions (mm)
Only Cabinet
Width
With Leg Front
Only Cabinet
With Door
Depth With Handle
90° Open
135° Open
Only Cabinet
Height With Hinge
With Door
• Allow clearance to the right, left, back
and top when installing.
This will help reduce power consumption
and keep your energy bills lower.
• Make sure you disconnect the water supply line
BEFORE removing the freezer door.
To avoid damage, refer to 'Separating the water
line from the refrigerator' in the manual (page
19).

SETTING UP THE REFRIGERATOR

Installing the handles

Important : If you need to remove the refrigerator's
doors to move it into place, install the handles after
you put the doors back on.
Take the handles out of the right side door.
The handles are included in the package.
English - 17
Model
RS25H50****
908
915.5
784
857.5
919
F 1169 / R 1295.5
F 1017.5 / R 1107
1742.5
1776
1776
2015. 6. 12. 11:20