Braun Easypump C-bloc RA Manual Del Usuario página 7

DESCRIPTION OF DEVICE (FIGURE 1)
The Easypump C-bloc* RA
®
Select-A-Flow* device incorporates a controller
that allows the user to adjust the infusion rate.
➊ Fill Port
➋ Easypump C-bloc* RA
®
➌ Clamp
➍ Air-Eliminating Filter
➎ Select-A-Flow* Variable Rate Controller
➏ Flow Rate Dial
➐ Rate-Changing Key
➑ Lockable Cover
MEDICATION LABEL (FIGURE 2)
Medication Label Symbol Definitions:
➊ Patient Name
➋ Date
➌ Time
➍ Medication
➎ Dosage
FIGURE 3:
➊ Der Grüne Punkt (For Germany only)
SELECT-A-FLOW* DEVICE DESCRIPTION
Select-A-Flow* device is a flow controller that
allows the user to adjust the infusion rate by
turning the rate-changing key on the device. The
flow rate is within a predetermined range and is
designated on each device.
TO DISCOURAGE TAMPERING (FIGURE 4)
1. Remove the rate-changing key from the dial
by pulling the key straight out. Put the key in
a safe place for later use, e.g., attached to a
key ring.
2. Close the cover over the Select-A-Flow*
Variable Rate Controller.
3. For increased tamper resistance, the cover
may be locked to the Select-A-Flow* Variable
Rate Controller using the tie-wrap.
Note: If desired, the cover may also be removed
from the Select-A-Flow* device by fully opening
the cover and then pulling straight up on the
plastic feet at the bottom of the cover.
WARNING: Do not rely on the
Select-A-Flow* key or tie-wrap to
prevent patient tampering.
Pump with
™
Pump
™
5
Figure 1
➊
➍
➑
Figure 2
➊
➋
➌
Figure 3
➊
Figure 4
Rate-Changing Key
Plastic Cover
Flow Rate Dial
➋
➌
➐
➏
➎
➍
➎
Tie Wrap