Epson Stylus TX235W Instrucciones De Seguridad Importantes página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations,
or dust.
Do not place or store the product outdoors.
Do not place the product near excessive heat sources or in direct sunlight.
Leave enough room around the product for sufficient ventilation. Do not block or cover
openings in the case or insert objects through the slots in the product.
Keep the product away from potential sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a
connector in the wrong orientation may damage both devices connected by the cable.
Do not touch the flat white cable inside the product.
Do not move the print head by hand; this may damage the product.
Do not spill liquid on the product or use the product with wet hands.
Do not use aerosol products that contain flammable gases inside or around the product.
Doing so may cause fire.
Do not press too hard on the scanner glass when placing originals.
Do not open the scanner section while the product is copying, printing, scanning, or
performing any other functions.
Be careful not to trap your fingers when closing the document cover or scanner.
Except as specifically explained in your documentation, do not attempt to disassemble or
service any part of the product yourself.
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are
fuses in the plug, make sure you replace them with fuses of the correct size and rating.
Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and
may prevent the product from printing.
Before transporting the product, make sure that the print head is in the home (far right)
position and the ink cartridges are in place.
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
To avoid adversely affecting the operation of the following equipment and causing an accident,
do not use the product: near medical equipment in a medical facility; within 8.7 inches (22 cm)
of a cardiac pacemaker; near automatically controlled devices, such as automatic doors or fire
alarms.
10
Important Safety Instructions

Publicidad

Tabla de contenido
loading

Tabla de contenido