Publicidad
STAND ASSEMBLY
1. Remove all contents from the carton.
2. Place Fan flat on the floor with the Motor facing towards the
ceiling. Make certain the Control Panel on the top of the motor
is facing forward. Orient stand halves as illustrated and install
(1) 1/4-20 X 1" Bolt through upper stand hole on both stand
halves. Place a Rubber Spacer between the stand halves and
the rear grill pivot bracket to left of motor. (Inset A) Secure the
bolt tightly.
3. MAKE CERTAIN HANDLE IS FACING OUTWARD AND IS ON
THE RIGHT SIDE OF THE MOTOR. While holding Handle in
position as shown, install (1) 1/4-20 X 1" Bolt thru Handle and
upper stand halves. Place a rubber spacer between the stand
halves and the rear grill pivot bracket to right of motor. (Inset
B) Secure the bolt tightly.
4. Install (1) 1/4-20 X 1" Bolt, (1) 1/4-20 Hex Nut and (1) 1/4" Lock-
washer to the remaining lower holes on each side of the Fan.
Rubber
Spacer
Inset 1A
(Figure 1)
Figure 1
Control
Box
Rubber
Spacer
Inset 1B
MODEL 9230
WHEEL ASSEMBLY
ASSEMbLE STAND COMPLETELY bEFORE INSTALLING
WHEEL ASSEMbLY
1. Place Mounting Bracket on the underside of the stand halves
to left of the motor as shown.
2. Install two #8 X 7/16 screws through the bottom of the stand
using a #2 Phillips Head Screwdriver.
3. Slide Axle Rod through Mounting Bracket.
4. Install the two wheels onto the Axle Rod and secure with
two Axle Cap Nuts. Press Axle Cap Nut onto Axle Rod.
#8 X 7/16"
Screws
OPERATION
1. Plug the fan into a properly grounded three-prong 120V AC
receptacle.
2. Using the rotary switch, set the desired fan speed: (0) Off, (3) High,
(2) Medium, (1) Low.
3. To Adjust Head Angle: Head will remain stationary when rotated
to desired position. Occasional tightening of pivot hardware may
be required after head is repositioned multiple times.
MAINTENANCE
WARNING:
ING OR SERVICING.
WARNING:
CLEANING:
tion, such as liquid dish washing detergent. Dry ALL PARTS COM-
PLETELY before reassembling. After any maintenance or servicing,
completely reassemble unit as described in this instruction manual
before reconnecting to the power supply.
CAUTION:
cleaners, etc. as they will damage the Fan. NEVER use
ALCOHOL OR SOLVENTS.
SERVICING: All other servicing, with the exception of general
user maintenance, should be performed by an authorized service
representative.
LUbRICATION: Precision bearings are sealed at the factory for
life and do not require further lubrication.
STORAGE: Store the Fan, with these instructions, in a clean and
dry place.
(Figure 2)
Axle Cap Nut
Wheel
Axle Rod
Mounting
Bracket
Wheel
Axle Cap Nut
ALWAYS UNPLUG THE CORD bEFORE MOV-
DO NOT IMMERSE FAN IN WATER!
Use a soft cloth moistened with a mild soap solu-
Do not use gasoline, benzine, thinner, harsh
Figure 2
Publicidad
