Environmental Protection; Safety Notices - Fagor 7CFV-92X Instrucciones Para Instalación

ENGLISH

ENVIRONMENTAL PROTECTION

- This appliance's packaging material is recyclable. Help recycle it and protect the environment by dropping it off in
the municipal receptacles provided for this purpose.
- Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used
appliances that should not be mixed with other waste. This way, the appliance recycling organised by your
manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/
96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used
appliance collection points closest to your home.
- We thank you doing your part to protect the environment.
N.B.:
Keep these instructions for use with the appliance. If you need to sell the appliance, or give it to another
person, make sure that these instructions for use go with it. Thank you for reading these notes before
installing and using your appliance. They have been drafted for your safety and that of others.

SAFETY NOTICES

The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must
be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account.
The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other
than electricity (central heating systems, thermosiphons, water-heaters, etc.).
Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct.
In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose.
The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity
(gas, oil, coal heaters, etc) operate at the same time.
In fact the intake hood, disposing of air, could create a vacuum in the room. The vacuum should not exceed 0,04mbar.
This prevents the gas exhausted by the heat source from being intaken again. It is therefore advisable to ensure the room
contains air taps able to ensure a steady flow of fresh air.
Check the data label inside the appliance; if the symbol (
technical particulars that it belongs to class II insulation, therefore it must not be earthed.
The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following
instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows: – the wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black; – the wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red. – terminal of a three-pin plug.
Check the data label inside the appliance; if the symbol (
appliance must be earthed. When making the electrical connections, check that the current socket has a ground
connection.
The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following
instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
– the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter
E or by the earth symbol [
to the terminal which is marked with the letter N or coloured black; – the wire which is coloured brown must be connected
to the terminal which is marked with the letter L or coloured red.
When making the electrical connections, check that the voltage values correspond to those indicated on the data plate
inside the appliance itself. In case your appliance is not furnished with a non separating flexible cable and has no plug,
or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance
of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation.
If your unit features a power lead and plug, position this so the plug is accessible.
Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance.
This appliance has been designed for use in private households.
Food should not be flame-cooked or the gas rings used without cooking vessels under the hood (any flames
sucked upwards may damage the appliance).
N.B.: In kitchens heated with a device connected to a chimney (e.g. a stove), the recyclable version
of the hood should be installed. Do not use the hob without the cassette filters. Any room where a cooker
hood is used at the same time as appliances using gas or any other fuel must be properly ventilated.
All manuals and user guides at all-guides.com
], or coloured green or green and yellow; – the wire which is coloured blue must be connected
) is printed, read the following: this appliance has such
) is NOT printed, read the following: ATTENTION: This