Fitting Instructions - Bort select AchilloStabil Plus Instrucciones De Uso

– do not wear it on open wounds
– do not use in case of intolerance of one of the materials used
– no re-use – this medical aid is intended for treating one patient
– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material.

Fitting instructions

1
Before putting it on, open the Velcro fasteners.
2
Grasp the upper edge of the BORT AchilloStabil Plus ankle support and pull it
over the foot until the crescent-shaped pads are placed in the area between
the Achilles tendon and the medial or lateral malleolus.
3
Place your foot on the ground and close first the upper and then the lower
Velcro fasteners.
For additional relief of the Achilles tendon, one of the heel cushions provided can
be inserted into the shoe on the side of the ailing leg. In order to avoid leg length
differences between the healthy and ailing sides, place the second heel cushion
provided in the shoe on the side of the healthy leg.
Removal
Open the three fasteners on the lower leg of the ankle joint support. Grasp the
support on the lower edge and pull it up over the foot.
Material composition
Polyamide (PA), elastodiene/latex (LA), elastane (EL)
The sewn in textile label provides the precise material composition.
The product contains latex and can trigger allergic reactions.
EN
09