Installation - Jocel JP4EV010100 Manual De Instruciones

INSTALLATION

1.Selection of the installation equipment
Drill holes on the table surface according to the sizes shown in the drawing. For the
purpose of installation and use, a minimum of 50 mm space shall be preserved around the
hole.
Be sure the thickness of the table surface is at least 30mm. Please select heat-resistant
table material to avoid larger deformation caused by the heat radiation from the hotplate.
Important
There must be a minimum distance of 100 mm between the hole and the
wall or adjoining cupboard. If the hob is more than 30 mm thick, or if it is
placed on a false top, the ventilation cover must be fitted as shown in the
figure 1
Figure 1
2. Placement
Your appliance could be installed above a drawer, a cupboard with door or an oven.
- To install your appliance above drawer
The electronic circuits of the induction hob must be cooled by a current
of fresh air as shown in the diagram, and the points below must be
carefully complied with. The greater the distance between the hob and
the cupboard underneath it, the better the hob will function. (shown in
the figure 2)
Important:
Your ceramic hob needs an air inlet at the rear and an air outlet at
the front.
Figure 2
-29-