Jocel JP4EV010100 Manual De Instruciones página 32

Connecting the mains supply cable
 The mains terminal block is located on the underside of the hob and the terminals are
accessible by removing the terminal block cover. This is done by depressing the front of the
cover and releasing it from the securing clips.

The cable connections must be in accordance with the diagram located on the bottom of the hob (see
above). The links must also be positioned as indicated.

You should use a good quality screwdriver to carefully, fully tighten ALL of the terminal screws.

If when the hob is first switched on, only two of the zones work, you should recheck that the
terminal screws are all fully tightened and the links are in position. This should be done before
contacting the Customer Care Department.

IMPORTANT: The appliance must NOT be connected to the mains supply by means of a 13A plug and
socket.

The cable can be looped if necessary, but make sure that is not

kinked or trapped when the hob is in position. Care must be taken to avoid the cable being in contact
with hot parts of the appliance.
Technology data:
Hob
4 Hob
Voltage Total Power
220-240V 6.0KW
Nominal Power
26.1A
-31-
Protection
32A