Kreg Micro-Pocket KPHA730 El Manual Del Propietario página 7

Operation – Drilling and Driving
Pocket-Hole Screws
1
Drill Pocket Holes
WARNING When drilling, always ensure that the workpiece is clamped
securely and that the jig handle is pressed down to its travel limit.
a. Place your prepared drill bit (B) with stop collar (D) into your drill.
b. Insert your drill bit (B) into the drill guide (1) and bring your drill up to
speed before contacting the workpiece to ensure correct rotation of the
drill bit.
c. Drill until the stop collar (D) stops going any deeper due to contact
between the stop collar (D) and drill guide (1). Remove the drill bit (B) from
the drill guide (1) while the drill bit is still rotating.
d. When you are finished drilling pocket hole(s), lift the jig handle to release
the clamping pressure; then remove your workpiece.
D
B
1
7