e-conolight E-AL Serie Instrucciones De Instalación página 3

INSTALLATION INSTRUCTIONS
E-AL and E-APA Series
BOX MOUNT
1. Remove the cover from the back box by removing (5) hex bolts.
Preparation of the back box for mounting is based on the power
supply configuration to be used. See below for options:
4" Octagonal Junction Box
Remove appropriate mounting screw knockouts on back box to
match the junction box along with the 2" diameter wireway knockout
in the center of the back box. Pull supply leads from junction box
through the center opening in the back box.
NOTE: Always secure the back box to the mounting surface with
fasteners in all four corners of the back box in addition to the
mounting screws on the junction box.
Conduit from Behind
Remove the center conduit entry knockout on back box and
mounting screw knockouts. Position back box over conduit.
Surface Conduit
Remove appropriate 1/2" conduit plug from side of back box and
attach customer supplied conduit. Use a sealing compound on the
threads to prevent leakage.
2. Mount the back box to the mounting surface using customer
supplied hardware. Apply waterproof silicone between housing
surface and perimeter of back box.
3. Open fixture by removing (8) screws on ribbed driver compartment
cover.
4. Place gasket supplied with back box over nipple on back box cover.
See Figure 6.
5. Insert nipple on cover through center hole in wall of fixture. See
Figure 7.
NOTE: Make sure support hinged bracket on top edge of cover is
positioned toward the top of the fixture, away from the lighted side
of fixture.
6. Align (2) threaded holes in the cover with the (2) bolt holes in the
side of the fixture and fasten cover to fixture using the (2) bolts and
(2) ceiling washers provided with the back box. Tighten bolts to 132
in lbs (15 Nm).
NOTE: When installing the ceiling washers, make sure the rubber
side is facing the inside of the fixture housing wall.
7. Route fixture ground wire, common wire, and voltage wire through
hole in wall of fixture/back box cover.
8. Locate the wire cable inside of the back box and attach the wire
cable to the fixture hook as shown in Figure 8. Carefully let the
fixture hang down.
9. Complete electrical connections. See Fixture Wiring section.
10. Unhook the wire cable from the fixture. Place the fixture onto the
back box by hooking the Support Hinged Bracket on the fixture over
the top groove on the back box. See Figure 9.
11. Secure the fixture to the back box by using (5) bolts that were
removed in Step 1. Tighten bolts to 132 in lbs (15 Nm).
Figure 6
Gasket
www.e-conolight.com
Document:
LPN00365X0001A0_A
Created By:
TMT
Figure 7
Support Hinged Bracket
Top of Fixture
Light Side of Fixture
Figure 8
Figure 9
Support Hinged Bracket
| 888.243.9445 | FAX: 262.504.5409
Date:
Fixture
Back Box
Wire Cable
Top Flange
Fixture
2017-02-20
007091
Fixture Hook
Back Box