Zoeller 1332-0006 Manual De Instrucciones página 20

IMPORTANT: If the pump fails to prime within five minutes:
7. Turn the power off at the breaker box. Check all pipe connections for leaks, making sure all
connections are water and air tight. Check the inlet pipe for any sagging, making sure the inlet pipe
is in a straight line to the pump. Watch for leaks or a milky color in the discharged water, which
indicates an air leak. Re-prime if necessary, following steps 1 through 6 above. Reset breaker at the
breaker box.
IMPORTANT: If the pump hums instead of pumping or turns off repeatedly, shut pump off
immediately. Check voltage. Pump is wired to run on 230 volts. If the pump cuts out or stops, you
may be attempting to connect to 115 volts. See PUMP ELECTRICAL INSTRUCTIONS to see how to
correctly change the motor voltage to 115 volts.
SPECIFICATIONS
HP
1-1/2
2
Item
HP
Number
1332-0006 1-1/2
1333-0006
MOTOR DATA CHART
Phase Volts Code Letter Max Amps
1 115
1 230
1 115
1 230
Capacity - U.S. Gallons per Minute
Discharge Pressure (PSI)
Vertical
Lift (FT)
15
10 66
15 62
20 54
25 40
10 67
15 63
2
20 59
25 37
18.0
G
9.0
21.0
G
10.5
PERFORMANCE
20 25 30
58 53 42
57 47 38
52 42 31
38 36 23
62 56 49
59 52 44
56 49 40
36 35 31
20
Locked Rotor
Amps
72.0
36.0
108.0
54.0
Inlet
Pipe
35 40
32 10
25 7
2 in.
13 3
12 0
39 27
34 25
2 in.
29 9
18 5
Outlet
Pipe
1-1/2 in.
1-1/2 in.