Grid Ceiling Installation (continued)
3
Connecting the electrical wires
□ Remove the driver cover to access the wiring and push connectors.
□ Insert the live black wire from the electrical outlet box into the push connector
opening labeled "ACL" in the driver box on the back of the LED flat panel (A).
□ Insert the neutral white wire from the electrical outlet box into the push connector
opening labeled "ACN" in the driver box on the back of the LED flat panel (A).
□ Connect the ground wire from the electrical outlet box to the yellow wire in the driver
box on the back of the LED flat panel (A).
□ If a 0-10v dimming circuit is available, insert the purple wire from the electrical outlet
box into the push connector labeled "DIM+" and the gray wire from the electrical
outlet box into the push connector labeled "DIM-" in the driver box on the back of the
LED flat panel (A).
□ Replace the driver cover once wiring connections are complete, fully tightening the
screw to hold it securely in place.
CAUTION: Do not allow the DIM+/- and LED +/- wires to make contact as it will cause
damage to the LED Driver.
4
Restoring power
□ Restore power at the electrical panel.
□ Turn on the light switch to activate the fixture.
5
Please contact 1-855-384-7754 for further assistance.
LED Driver
www.ETiSSL.com