Suspension Mounting (continued)
4
Attaching the LED flat panel to the
aircraft cables
□ Bend each of the mounting clips on the back of the LED flat
panel (A) upward until they are perpendicular to the back
surface of the flat panel.
□ Attach the S hooks at the bottom of the aircraft cables (AA) to
the mounting clips on the LED flat panel (A).
□ Slide the quick cable-lock down each aircraft cable to position
the LED flat panel (A) at the desired height.
□ Push in the bottom cable release while firmly holding the
aircraft cable and feed it back through the quick cable-lock to
further adjust the height, if needed.
NOTICE: The LED flat panel (A) must hang a minimum of 3 in. from the ceiling.
5
Connecting the electrical wires
□ Remove the driver cover to access the wiring and push connectors.
□ Insert the live black wire from the electrical outlet box into the push connector
opening labeled "ACL" in the driver box on the back of the LED flat panel (A).
□ Insert the neutral white wire from the electrical outlet box into the push connector
opening labeled "ACN" in the driver box on the back of the LED flat panel (A).
□ Connect the ground wire from the electrical outlet box to the yellow wire in the
driver box on the back of the LED flat panel (A).
□ If a 0-10v dimming circuit is available, insert the purple wire from the electrical
outlet box into the push connector labeled "DIM+" and the gray wire from the
electrical outlet box into the push connector labeled "DIM-" in the driver box on the
back of the LED Flat Panel (A).
□ Replace the driver cover once wiring connections are complete, fully tightening the
screw to hold it securely in place.
CAUTION: Do not allow the DIM+/- and LED +/- wires to make contact as it will cause
damage to the LED Driver.
6
Restoring power
□ Restore power at the electrical panel.
□ Turn on the light switch to activate the fixture.
Quick Cable Lock
AA
Mounting Clip
7
Please contact 1-855-384-7754 for further assistance.
A
LED Driver
www.ETiSSL.com