Kohler K-2314 Guia De Instalacion página 5

Fireclay Model
Pinch wing
nut closed to
insert into
lavatory hole
Pocket in back
of lavatory
Insert bolt and washer through
back of lavatory and attach to wall
4. Install the Lavatory to Brackets and Wall (Fireclay Model)
- Install assembled 1/8" bolts into the front holes of the lavatory as shown.
- Temporarily place the lavatory on the brackets. Insert the bolts into the slots located in the sides of the tie bar.
- Locate holes in back of lavatory and mark on wall. Remove lavatory and predrill holes. Replace lavatory on
brackets and reinsert bolts.
Risk of product damage. Do not overtighten the lag bolts. Overtightening may damage the lavatory.
- Insert two lag bolts and washers (not provided) through holes located in pockets in back of lavatory and attach to
wall. The type of lag bolts and washers needed will vary according to the finished wall.
- Tighten down all the bolts.
5. Install the Lavatory to Brackets and Wall (Marble Model)
- Move the marble lavatory into place.
- Install four 10 mm hex bolts and washers through the holes in the brackets and into the threaded holes in the
lavatory.
Risk of product damage. Do not overtighten the lag bolts. Overtightening may damage the lavatory.
- Tighten down all the bolts 1/4 turn past fingertight.
Kohler Co.
Toggle Wing Nut
1/8" Bolt
Washer
As Viewed From
Below
Insert toggle
bolt into slot
Marble Model
Lavatory
5
Washer
Bolts
Brackets
1012580-2-
B