Removal Of Cooking Hob - Bosch HSE6RAG400 Modo De Empleo E Instrucciones De Montaje

Provide an omnipolar cut-off switch with a minimum
contact separation of 3mm (except in plug
connections, so long as the user has access to it).
This appliance is type "Y": The entrance cable can
only be changed by the Technical Assistance Service,
and not by the user. The cable type and minimum
section must be respected.
The hob is fitted with a 6 x 1,5mm2 electrical cable
made of silicone suitable for a 220-230V, 2 phase
connection. For any other connectioon, see figure 5.
For safety reasons, the earthwire must be the first to
connect, and the last to disconnect.

Removal of cooking hob

Turn off the appliance's electricity supply.
Unscrew the clamps and proceed in reverse order to
the installation.
18