Completing A Measurement - WEBTEC HPM7000 Manual De Instrucciones

6.6

Completing a Measurement

The description below explains how to complete a measurement
according to an example:
1 Switch the device on. Further information is available in Chapter &
"Switching the Device On and Off".
2 Connect the sensors to the device according to your application.
Further information is available in Chapter & "Connecting the
Sensors".
3 Setup the channels displayed according to your application. Further
information is available in Chapter & "Edit Channels".
4 Select a measuring method. Further information is available in
Chapter & "Measuring Methods".
5 Tap on the Start/Stop button to start a measurement. Alternatively,
wait until the defined trigger is triggered.
Ä Recording of the measured data is started.
6 To stop the measurement, based on the measuring method selected:
Tap on the Start/Stop button, wait for the defined storage time to
expire, wait for the defined trigger to trigger.
Ä Recording of the measured data is stopped.
After recording is stopped, the measured data is saved in the Service
Project Container (SPC) at the defined storage location. Further
information is available in Chapter & "Project Management".
You can access the measured data via the File Manager in order
to complete evaluations. Further information is available in Chapter
& "File Manager".
Operation
81