Shark AI ROBOT VACMOP Instrucciones página 15

STEP 1
PREP YOUR HOME
• Before cleaning, clear cords and remove small
objects like clothing or toys that are less than
8cm tall.
• Open interior doors in rooms you want your robot
to clean.
STEP 3
SET UP THE DOCK
1m
1m
PLACE
1.6m
DOCK
ON BARE
FLOOR
• Find a permanent location for the dock in a spot
with a strong Wi-Fi signal.
• Place the dock on bare floor, away from rugs or
carpets, with its back against the wall.
• Attach the landing mat to the bottom of the dock.
• Plug in the dock. The indicator light will illuminate
green when the dock has power.
STEP 5
DOWNLOAD THE SHARKCLEAN APP
SharkClean
App Features
✔ Scheduling
✔ No-Go Zones
✔ Mopping Modes
✔ Vacuum Modes
✔ Carpet Detection
Search "SharkClean" in the app store to download
the app.
• To use the app, your phone must be
connected to a 2.4 GHz network. The app
will not work on a 5 GHz network.
• DO NOT use a VPN or a proxy server.
• Make sure Wi-Fi isolation is turned off on the router.
SETUP
STEP 2
PREP THE ROBOT
.......... Side Brushes ..........
• Remove protective film from robot and dock.
• Attach side brushes.
• Power on your robot using the side switch.
STEP 4
CHARGE THE ROBOT
6
h
First
Charge
INDICATOR
1m
1m
Place robot on dock to charge. The dock indicator
light will turn blue and the robot will beep when
1.6m
charging begins.
CAN'T CONNECT?
Restart your phone
Reboot your robot
• Press the power button on the side of the ROBOT to
the OFF position for 10 seconds, then press it again
to turn power back ON.
Reboot your router
• Unplug the router power cable for 30 seconds, then
plug it back in. Allow several minutes for your router
to reboot completely.
Having trouble connecting to your robot?
For How-to Videos Troubleshooting, FAQs, and Tips
& Tricks visit: sharkclean.eu
Your robot will need to complete 2 different runs
WITHOUT the fluid reservoir attached before it
POWER
can mop.
Step 1. Explore Run – First, the robot will wander
around exploring your home as it creates a map.
Step 2. Carpet Detection Run – As it vacuums row
by row, the robot will also detect carpets and rugs to
avoid later, when mopping.
Now you're ready to clean.
Attach the fluid reservoir to your robot to enter VACMOP Mode.
In this mode, your robot will vacuum and mop simultaneously.
ATTACH MOPPING PAD
• Insert the flat edge of the pad through the slot
in the fluid reservoir.
• Secure to the back of the reservoir.
INSERT RESERVOIR INTO ROBOT
• Firmly push the
reservoir into the
back of the robot.
(Do not remove
the dustbin.)
• BOTH sides of the
reservoir should
CLICK when it
slides into place
completely.
• The water droplet
icon will
( )
illuminate when
reservoir is
properly inserted.
• Your robot is
ready to
simultaneously
vacuum and mop
your hard floors.
BEFORE YOU CLEAN
INTERACTIVE MAP WITH CARPET DETECTION
HOW TO SET UP VACMOP MODE
FILL FLUID RESERVOIR
• Fill the reservoir with room temperature water up to
the MAX fill line.
REMOVE MOP ACCESSORIES AFTER USE
• Slide out the fluid reservoir.
• Empty the fluid reservoir.
• Remove the pad and
follow the care
instructions on the
back of the pad.