Shark AI ROBOT VACMOP Instrucciones página 22

MAINTENANCE
CAUTION: Turn off power before performing any maintenance.
NOTE: Even when the switch is in the OFF (O) position, the robot still uses a
small amount of power.
EMPTYING THE DUSTBIN
With the fluid reservoir removed, press the Dustbin
Release Button and slide out the dustbin.
Empty debris and dust into dustbin. Wash dustbin
if necessary, using water only.
NOTE: Make sure to insert the dustbin completely, until it
clicks into place.
s h a r kc l e a n . e u
To open the dustbin lid, press and hold the button
while lifting the lid, using the finger slots.
To avoid mould, clean the area between the filter
and the plastic shield after every mopping run, and
periodically after vacuuming. Remove the shield
and clear any debris buildup with a dry cloth or
soft brush.
MAINTENANCE
CLEANING AND REPLACING THE FILTER
For optimal suction power, after each use, clean and reinsert the filter inside the robot's dustbin.
See sharkclean.eu for replacement filters.
Remove and empty the dustbin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dustbin.
Lightly tap the filter to remove debris every time
you empty the dustbin. For a deeper clean, rinse
the filter with water once a month. Allow the filter
to air-dry for up to 24 hours before reinstalling. Do
not use soap or scrub the filter. This will damage
the material.
NOTE: Replace the filter once a year for optimal performance.
Pull filter out of the dustbin by the tabs.
Reinsert the filter into the dustbin, then slide the
dustbin back into the robot until it clicks into
place.
s h a r kc l e a n . e u