Shark AI ROBOT VACMOP Instrucciones página 19

BUTTONS AND INDICATOR LIGHTS
s h a r kc l e a n . e u
CLEAN BUTTON Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it
cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For
Press to begin a cleaning
best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas
session. Press again to stop.
are regularly maintained.
NOTE: Scheduling is one of numerous features that can only be done in the app.
DOCK BUTTON
Press to stop cleaning and
send robot back to the
charging dock.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
WET MOPPING INDICATOR
LIGHT
Illuminates when fluid
reservoir is properly installed.
Droplet icon will turn red
if there is no fluid in the
reservoir. After 15 minutes,
the robot will return to dock
if reservoir is not filled.
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
To manually start a cleaning cycle, press the Clean button on the robot or on the mobile app. To
immediately send the robot back to the dock, press the Dock button.
WI-FI INDICATOR
White light: connected to
Wi-Fi.
Red light: not connected.
Flashing White: setup mode.
No light: not set up yet.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
PREP YOUR HOME
OBSTRUCTIONS
Clear cords and small objects
less than 8cm in height, and
open interior doors to ensure
a complete map of your
home.
THRESHOLDS
Your robot can climb over
most thresholds to get from
room to room, but if one is
too high, set up a no-go zone
in the app to block it off.
STAIRS
Your robot's cliff sensors
will prevent it from falling
off ledges. For the cliff
sensors to work properly in
any mode, all runners, rugs,
or carpets must be at least
20cm from any stairs, or
must extend over the edge of
the stairs.
MANUAL CLEANING MODE
SCHEDULING
Schedule whole-home cleans
with the app. To schedule a
mopping run with the app,
the reservoir must be filled
and installed in the robot with
the pad attached.
AVOID MOVING THE
ROBOT & DOCK
While your robot is cleaning,
do not pick it up and move it,
or move the charging dock—
this will impact the robot's
navigation and ability to
return to dock when cleaning
is complete.
REMOVE RUGS FROM
DOORWAYS WHEN
MOPPING
Before mopping, you must
set up Carpet Detection in
the app, and move any car-
pets or rugs that block access
to floors that you want your
robot to mop.
s h a r kc l e a n . e u