4. Secure the upper handle to the handle brackets with
the knobs and carriage bolts. Make sure the knobs are
tightened (Fig. 4).
Fig. 4
Chute Crank Assembly
1. The cotter pin comes pre-assembled on the unit, as
shown. Remove the cotter pin and proceed to step 2
(Fig. 5).
Fig. 5
Cotter pin
2. Install the crank rod through the center plate and insert
it into the opening at the back of the housing with holes
aligned (Figs. 6 – 8).
Fig. 6
NOTE: Loosen or tighten the crank adjustment knob as
needed to allow for smooth control of the crank rod.
Fig. 7
Fig. 8
3. Secure the crank rod in place and replace the cotter pin
(Figs. 9 – 10), as shown.
Fig. 9
7