Troubleshooting - Troy-Bilt RZT Serie Manual Del Operador

Troubleshooting

Problem
Excessive vibration
Uneven cut
Mower will not mulch grass
(If Equipped w/Mulching Kit)
Cause
1. Cutting blade loose or unbalanced.
2. Damaged or bent cutting blade.
1. Deck not leveled properly.
2. Dull blade.
3. Uneven tire pressure.
1. Engine speed too low.
2. Wet grass.
3. Excessively high grass.
4. Dull blade.
Remedy
1. Tighten blade and spindle.
2. Replace blade.
1. Perform side-to-side deck adjustment.
2. Sharpen or replace blade.
3. Check tire pressure in all four tires.
1. Place throttle/choke control lever in FAST
(rabbit) position.
2. Do not mulch when grass is wet.
3. Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting swath.
4. Sharpen or replace blade.
8
33