Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Engine fails to start
Engine runs erratic
Engine Overheats
Excessive Vibration
Drivebelt Slips
Cause
1.
Dirty air cleaner
2.
Engine needs to be primed
3.
Fuel tank empty
4.
Stale fuel in gasoline tank
5.
Spark plug wire disconnected.
6.
Spark plug fouled
7.
Engine flooded
1.
Spark plug wire loose
2.
Stale fuel in gasoline tank
3.
Vent in gas cap plugged
4.
Water or dirt in fuel system
5.
Dirty air cleaner
6.
Carburetor out of adjustment
1.
Engine oil level low
2.
Air flow restricted
3.
Dirty air filter
4.
Carburetor not adjusted properly
1.
Edger blade bent or damaged
2.
Blade spindle bent or damaged
1.
Belt worn or stretched
Remedy
1.
Refer to the Engine Operator's Manual
2.
Push primer bulb two or three times.
3.
Fill tank with clean, fresh gasoline.
4.
Drain gasoline and refill tank with clean,
fresh gasoline.
5.
Connect the spark plug wire to the spark
plug.
6.
Clean, adjust gap or replace spark plug.
7.
Refer to the Engine Operator's Manual.
1.
Connect and tighten spark plug wire.
2.
Drain gasoline and refill tank with clean,
fresh gasoline.
3.
Clear vent of any debris.
4.
Drain fuel tank. Refill with fresh fuel.
5.
Refer to the Engine Operator's Manual.
6.
Refer to the Engine Operator's Manual.
1.
Fill crankcase with proper oil.
2.
Clean the area around the engine's cooling
fins.
3.
Replace the engine's air filter.
4.
Refer to the Engine Operator's Manual.
1.
Replace edger blade.
2.
Contact an authorized MTD service dealer.
1.
Replace drive belt.
8
15
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
