Kohler Sterling 65010140 Guía De Instalación Y Cuidado página 4

Mounting
Boss
1/2"
(13 mm)
Clip
2. Install the Sink
NOTE: To avoid possible damage to the cabinet, cut the countertop
before installing the countertop to the cabinet.
Cut out the countertop opening by carefully following the pencil
line traced from the template.
Install the countertop to the cabinet.
Install the faucet and drain to the bathroom sink.
Carefully position the sink in the cut-out opening.
Select the appropriate mounting clip position based on the
countertop thickness. Refer to above illustration.
Secure the bathroom sink with the six provided mounting clips
and screws.
Apply a thin continuous bead of sealant around the sink edge.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Verify that the sink has not moved out of position.
Allow the sealant to cure for at least 30 minutes before
proceeding.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet.
Run water into the bathroom sink and check for leaks.
1032676-2-C
Adhesive
(Not Furnished)
5/8" 3/4" (19 mm)
(16 mm) and Thicker
4 Sterling