Technical Data - Hansgrohe Talis S 32851 Serie Manual Del Usuario

Important! The fitting must be installed, flushed
and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the metall
washer and collar over the hoses and threaded
base and tighten the collar nut by hand. If there
is not enough space, please use only the slide
washer and the metal washer without the plastic
washer.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
6. 38XXX:
Connect a dish washer or a washing machine
to the thread DN20 (¾ ").
The hot and cold supplies must be of equal pres-
sures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left
turning to the right = cooler water,
turning to the left
turning to the right = stop valve closed.

Technical Data

Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
= warmer water,
= stop valve open,
max. 1.0 MPa
1.6 MPa
max. 80° C
65° C
11 l/min 0.3 MPa
English
To adjust the hot water limiter on single lever mixers,
please see page 21.
No adjustment is necessary when using a continuous
flow water heater..
Spare parts (see page 4)
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 aerator cpl.
6 fixing set
7 connection hose 600 mm 3/8
8 connection hose 900 mm
9 shut off unit, Elastop
10 turning handle
11 supply pipe
12 sealing set
XXX = Colors
000 chrome plated
800 stainless steel optic
32892XXX
96338000
97995XXX
97996000
92730000
13913XXX
95049000
96556000
96316000
94849000
97213XXX
97965000
98702000
7