Storage; Ordering Accessories; Guarantee And Support; Frequently Asked Questions - Philips AVENT SCD565 Manual Del Usuario

10 Storage

If you are not going to use the baby monitor for
some time, do the following:
•
Remove the non-rechargeable batteries from
the baby unit.
• Remove the rechargeable batteries from the
parent unit.
•
Store the parent unit, the baby unit and the
adapters in a cool and dry place.

11 Ordering accessories

To buy accessories or spare parts,
visit www.shop.philips.com/service or go to
your Philips dealer. You can also contact the
Philips Consumer Care Centre in your country
(see the worldwide guarantee leaflet for contact
details).
12 Guarantee and
support
If you need information or support, please visit the
Philips website at www.philips.com/support
or read the separate worldwide guarantee leaflet.
13 Frequently asked
questions
This chapter lists the questions most frequently
asked about the appliance. If you cannot find the
answer to your question, visit
www.philips.com/support for more frequently
asked questions or contact the Consumer Care
Centre in your country.
What is Eco Max mode? How does this mode
help the environment?
• The Eco Max mode has been developed to
enable you to reduce the energy consumption
of your baby monitor. When you monitor your
baby from a small distance, you can activate the
Eco Max mode. By switching on the Eco Max
mode, your baby monitor uses less energy and
is therefore more environment-friendly.
Why don't the power-on light of the baby unit
and the 'link' light of the parent unit come on
when I press the on/off buttons of the units?
• Perhaps the rechargeable batteries of the
parent unit are empty and the parent unit is not
plugged in. Insert the small appliance plug into
the parent unit and put the adapter in a wall
socket. Then press the on/off button to establish
connection with the baby unit.
• Perhaps the non-rechargeable batteries of the
baby unit are empty and the baby unit is not
connected to the mains. Replace the
non-rechargeable batteries or connect the baby
unit to the mains. Then press the on/off button
to establish connection with the parent unit.
• If the 'link' light on the parent unit still does not
start flashing red, use the reset function to reset
the units to their default settings.
19