Kobalt KRW 124B-03 Manual Del Usuario página 10

OPERATING INSTRUCTIONS
3. Variable-speed Trigger Switch
a. To turn the ratchet wrench ON, press the
variable-speed trigger switch (D).
b. To turn it OFF, release the variable-speed
trigger switch.
c. The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
4. LED Worklight
The LED worklight (C), located on the underside of
the wrench, will illuminate when the trigger switch
is depressed. This provides additional light on the
surface of the workpiece for operation in lower-light
conditions.
The LED worklight will turn off approximately 10
seconds after the trigger switch is released.
a. The LED worklight will blink rapidly if the tool
has stopped working because of an overload or
overheating situation; please wait for the tool to
cool down, at which point it can be started again.
b. The LED worklight will blink slowly to indicate
that the battery charge is very low.
5. Installing and Removing Socket
a. Remove the battery pack.
b. To install a 3/8 in. socket (not included), simply
push it completely onto the square anvil (A).
c. To remove the socket, pull it off.
WARNING
• Only use sockets designed for ratchet wrenches.
Sockets not designed for wrenches could break
and result in user injury. Inspect sockets prior to
use to ensure that they have no cracks or other
visible damage.
• Use protective gloves when removing the socket
from the tool, or first allow it to cool down. The
socket may be hot after prolonged use.
3
4
5
A
10
D
C