Thermo-Electric Cooler Recliner With 2-Motor Massage & Heat Assembly Instructions - La-Z-Boy La-Z-Touch Instrucciones De Operación

Thermo-Electric Cooler Recliner with 2-Motor
Massage & Heat Assembly Instructions
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
NOTICE:
Do not plug the transformer in until instructed.
1. Install the back.
Lay the back across the chair arms. Lift the back at a slight angle and align
•
the brackets on the back with the brackets on the body (F
Lower the back onto the body, making sure the back and body brackets are
•
completely engaged.
- To make sure the back is properly installed, with both sets of back and body brackets
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position, the brackets are not engaged (F
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
Lock the brackets by using a screwdriver to push down the locking levers (F
•
2. The thermo-electric cooler power transformer, 2-motor massage and heat power transformer
and rubber mat are stored inside the cooler during shipping. Remove the power transformers
from the cooler and unwind the cords.
NOTICE:
– To reduce the risk of product damage:
• Before operating, remove the white packing material located under
the cooler, inside the arm cavity.
3. Packing material is used under the thermo-electric cooler to protect and support the cooler
during shipping. The packing material must be removed before operating the cooler to prevent
damage. Lift the thermo-electric cooler from the chair arm and set in the seat (F
Remove the white packing material from inside the arm cavity (F
4. Carefully lower the thermo-electric cooler into the chair arm, making sure the power connector
is toward the back of the chair (F
IGURE
5. To access the massage connectors, stand at the side of the chair and push the back
rearward to recline the seat and back. Hold the top arm closed to prevent the cooler from
falling out, and gently tip the chair forward to rest on its arms and the top of the back.
(Assembly Instructions Continued)
6
1).
IGURE
2). Remove the back and
IGURE
® dealer for assistance.
IGURE
5).
IGURE
6).
Thermo-Electric Cooler Recliner with 2-Motor
Massage & Heat Assembly Instructions
F 1
IGURE
Body
Bracket
Back Bracket
3).
F 3
IGURE
Back
Bracket
4).
IGURE
F 5
IGURE
White Packing
Material
F 2
IGURE
Back and body brackets on this side
are not engaged. Remove the back
and reinstall.
F 4
IGURE
Locking
Lever
Locked
Position
F 6
IGURE
Thermo-Electric Cooler
Power Connector
Chair
Back
7