La-Z-Boy La-Z-Touch Instrucciones De Operación página 6

La-Z-Touch 2-Motor Massage & Heat Recliner
®
Operating Instructions
DANGER
– To reduce the risk of serious injury:
• Plug directly into a wall outlet. Do not use an extension cord, adapter,
or surge protector.
WARNING
– To reduce the risk of serious injury:
• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the
back of the unit. Move the unit into or out of the reclining position slowly, making
sure that no children or pets are in close proximity.
• The 01M/01N chair is intended for a single occupant, not exceeding 250 pounds.
Do not operate the chair with more than one occupant in or on any part of the chair.
• To safely exit the unit and prevent a tripping hazard, bring the back
upright and close the legrest.
Operating Instructions for 2-Motor Massage and Heat
Plug the 2-motor massage and heat power transformer directly into a wall outlet. Make sure
there is enough slack in the cord running from the chair to the outlet to allow for rocking and
reclining. Never stretch or strain a cord.
Automatic Timer Operation
The system has an automatic timer that will shut off the MASSAGE and HEAT functions after
approximately 15 to 30 minutes of operation.
• Pushing down on the POWER button or either zone button will restart the massage.
• Pushing down on the HEAT button will restart the heat. Push down once for Low Heat
and twice for High Heat.
• When you are finished, make sure to push the POWER button and the HEAT button
(if activated) to turn the system off. Press the HEAT button twice if in Low Heat setting.
• The timer will also reset if you unplug the 2-motor massage and heat power transformer or
if there is a power outage.
The massage and heat functions may start automatically when electrical power is restored after
a power outage. The timer should automatically shut down the massage and heat within 15 to
30 minutes. There should be no risk of injury or damage if this happens. However, we
recommend that you unplug the power transformers if you will be away from your residence
for an extended period of time.
Transformer specifications depend on production date. Refer to transformer
to determine which specifications apply to your product.
La-Z-Touch 2-Motor Massage and Heat Power Transformer Specifications:
Input: 120V AC 60Hz 30W, Output: 12V AC 1500mA
Input: 100-240V AC 50-60Hz 1.5A, Output: 13.8V DC 2.9A
10
or
La-Z-Touch 2-Motor Massage & Heat Recliner
®
Operating Instructions
P P O O W W E E R R
Activates massage
system when button
is backlit with LED.
Press once for 15-min.
timer. Press and hold
down for 30-min. timer.
To restart unit
NOTE:
after timer shuts off,
press either ZONE or
PWR button.
Z Z O O N N E E S S
Activates any or all zones.
LED indicates which zone(s)
has been selected.
I I N N T T E E N N S S I I T T Y Y
Will increase (+) or
decrease (-) intensity
during all modes.
WARNING
– To reduce the risk of serious injury:
• Do not use unit if power control is damaged or wet. Do not use unit if the hand wand has
been dropped in water or any liquid. Contact your La-Z-Boy
H H E E A A T T
Activates heat. Press
once for low and
twice for high. Use
independently or with
massage feature.
Heat will
NOTE:
deactivate in 30
minutes. To restart,
press the HEAT
button again.
M M O O D D E E S S
- Choose either
ZONE
or both zones for massage.
- Massage turns
PULSE
on and off to simulate
a pulsing action.
- Massage moves
WAVE
up and down or side to
side, depending on style,
in a wave-like action.
S S P P E E E E D D
Controls pulsing frequency
of massage in PULSE mode
and controls velocity as it
cycles through in WAVE mode.
Press (+) to increase and (-)
to decrease.
® dealer for service.
11