Stopping Engine - Lea LE32254-25A Instrucciones Originales

Stopping engine

1) To stop the engine, lower the switch lever to the "0 " position (Fig.27).
2) After using the chain saw for long periods of time, it is advisable to let the engine run at idle
speed or several seconds before operating the "0 " switch lever.
ATTENTION! Accustom yourself to operating the STOP switch so that you will be able to
act promptly in the event of an emergency.
ATTENTION! The chain will continue to move for some time after the throttle lever is
released.
Starting a warm engine
1) Raise the switch lever "I" (Fig 31 part.1).
2) Pull the air knob as far as it will go and then push it in to engage "THROTTLE ADVANCE-
MENT" - START.
3) Give the starter cord handle a strong pull until the engine starts fig. 34.
Starting with the engine hot after refuelling
1) If the fuel tank has been emptied completely, after refuelling follow the instructions given for
"starting with the engine cold ".
STOPPING THE ENGINE. The engine must always be stopped in the following cases:
When refuelling
-
- When oiling the chain
When carrying out checks and repairs
-
- When cleaning and adjusting the chain saw
When moving the chain saw in the working area
-
During transport
-
CHAIN SAW OPERATION
When necessary, this special type of chain saw may be used with a single
-
hand by a trained operator who is using a correct and safe working method to prune trees
-
and remove branches; all other operation, on the other hand, must be carried out 2 hands,
as required with a traditional chain saw (fig.11-A).
Comply with all safety rules described in chapter "SAFETY".
-
- Cut the tree by pushing the throttle lever all the way and come into contact with the wood
after the engine has reached full speed.
Using the chain saw on trees with ropes and slings
The following instructions are only examples of how to use the chain saw in the
best possible way: however, all current local and national laws must always be complied
35