Fisher-Price 71566 Manual Del Usuario página 15

L
e
PROBLEM
No sound
Interference
(buzzing, static, etc.)
and signal indicator on
receiver is "ON"
Interference
(buzzing, static, etc.)
and signal indicator on
receiver is "OFF"
Interference
(garbled voices) and
signal indicator on
receiver is "ON"
Feedback
(squealing or whistling)
All five bars on the
receiver variable lights
display light (and you
hear static)
e Problems and Solutions Guide
f Guide de dépannage
S Guía de Problemas y Soluciones
PROBABLE CAUSE
Channel switches not on same setting
Signal interference due to monitors,
cordless telephones, etc.
Out of range or insufficient signal
Volume not turned up
Improper antenna position
Weak or dead batteries
AC adaptor not properly connected
Signal interference due to another
nursery monitor or cordless
telephone, etc.
Channel switches not on same setting
Signal interference due to other
nursery monitors or cordless
telephones, etc.
Channel switches not on same
setting
Receiver power is "ON" but
transmitter power is "OFF"
Code switches in receiver and
transmitter do not match
Signal interference due to another
Fisher-Price ® Direct Link Privacy
Monitor TM
Receiver is too close to the transmitter
Volume is set too high
Out of range or insufficient signal
Channel switches not on same
setting
Set channel switch on transmitter and receiver to the same
channel.
Change the channel setting on both the transmitter and the
receiver.
Identify and eliminate the source of interference.
Test reception by moving the transmitter and/or receiver to
different locations throughout the house. Relocate the transmitter
and/or receiver.
Test reception by moving the transmitter and/or receiver to
different locations throughout the house. Relocate the transmitter
and/or receiver.
Adjust volume on receiver.
Make sure the antenna on the transmitter and receiver are
pointing upward.
Replace the battery in the receiver with a fresh 9V alkaline battery,
and the batteries in the transmitter with four size "C" alkaline
batteries or use the AC adaptors.
Check AC adaptor jack-to-socket and plug-to-outlet connections.
Change channel switch on both transmitter and receiver to the
other channel.
Check channel switch on transmitter and receiver to be sure they
are on the same channel.
Change channel switch on both transmitter and receiver to the
other channel.
Identify and eliminate source of interference. Do not use more
than one transmitter at the same time in the same house.
Check channel switch on transmitter and receiver to be sure they
are on the same channel.
Make sure transmitter power is "ON".The power indicator should
be lit.
Reset code switches in receiver and transmitter so that they
match.
Make sure transmitter power is "ON".
Change channel switch on both transmitter and receiver to
the other channel.
We recommend "Checking Privacy" periodically. See page 9.
Move receiver further from transmitter.
Lower volume on the receiver.
Move the receiver closer to the transmitter.
Check channel switches on transmitter and receiver to be sure
they are on the same channel.
1 5
SOLUTION