Harbor Breeze SAWGRASS Manual Del Usuario página 11

WIRING
1C. FAN AND LIGHT CONTROLLED BY TWO
WALL SWITCHES: If you intend to control the
fan and light with separate wall switches,
connect BLACK wire from fan to BLACK wire
from the independent wall switch for the fan.
Connect BLUE wire from fan to the BLACK wire
from the other independent wall switch for the
light. Connect WHITE wire from fan to WHITE
wire from ceiling. Connect all GROUND
(GREEN) wires together from fan (on downrod
(A) and mounting bracket (C)) to BARE/GREEN
wire from ceiling. (Fig. 1C)
NOTE: Black wire is hot power for fan. Blue wire is
hot power for light kit. White wire is common for
fan and light kit. Green or bare wire is ground.
Wrap electrical tape (not included) around each
2.
individual wire connector (CC) down to the wire as
shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of
box from the black and blue (if applicable)
connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
E3 Wire Connector
CC
3. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will cause a loud
humming noise from fan. To reduce the risk of fire
or electrical shock, do NOT use a full range dimmer
switch to control fan speed. (Fig. 3)
FAN AND LIGHT CONTROLLED BY TWO WALL
SWITCHES
1C
120 V Power
FROM
CEILING
BLUE
BLACK
FAN
GREEN
2
CC
x4
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
11
BLACK (WALL SWITCH)
BLACK (WALL SWITCH FOR LIGHT)
WHITE
GROUND/GREEN (BARE)
WHITE
GREEN
WHITE
FROM FAN
CC
3
2
1
Speed
Switch
CC