Important; Fan Mounting - Harbor Breeze SAWGRASS Manual Del Usuario

INITIAL INSTALLATION
4. Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers provided
with the outlet box. (Fig. 4)
*NOTE: It is very important that you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT: If using the angle mount, make sure
open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
5. Remove motor screws (J) and lock washers (K)
from underside of motor. (Fig. 5) Save motor
screws (J) and lock washers (K) for later use.

FAN MOUNTING

1.
Remove pin (L) and clip (M) from motor housing
yoke at top of motor housing (E) and partially
loosen set screws. (Fig. 1)
*Helpful Hint: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer
downrod (not included) than the one provided.
Angle style mounting is best suited for angled or
vaulted ceilings. A longer downrod is sometimes
necessary to ensure proper blade clearance.
4
2 5
2
E
1
M
E
7
C
J
K
Set
Screw
L