Worx WG430E Traducción De Las Instrucciones Originales página 10

cauTION: Directly cleaning the
motor housing with water will lead
to permanent damage to the motor.
2. rEPLacEmENT OF cuTTINg LINE(See
Fig.k)
Replace cutting line (e) when a noticeable
decrease in shredding efficiency in observed.
To remove used cutting lines, cut the old lines
and pull the remaining line out of the spinner
head (f). When installing new cutting lines
place each end of the new line through the
two holes in the post on top of the spinner
head and through so that both ends of the line
are even. Then thread the lines through each
corresponding ferrule so that both ends of the
line are even. NOTE: There is a built in line
cutter that will cut and trim lines shortly longer
than desired.
warNINg: For optimum
performance use only wOrX
branded replacement lines. aftermarket
monofilament lines having max diameter
of 2.4mm diameter maximum length
of 370mm long could be temporarily
substituted. use of thicker lines, lines
made of substitute material, or lines
greater than 370mm long may result in
10 10
permanent damage to your motor and/
or injury and will void the manufacturer's
warranty. Immediately replace any worn
parts of the spinner head.
3. STOragE (See Fig.L)
When the leaf mulcher is stored at the end
of the season, disassembles and stack in the
following order:
a) Place the funnel into the stand,
b) Fit the motor into the funnel.
c) Place the funnel cover onto the motor.
d) Rest the legs on top of the funnel cover.
Leaf mulcher
EnVIROnmEnTAL
pROTECTIOn
Waste electrical products should not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
En