Andis RACR Manual De Uso Y Cuidado página 3

14. Use of a charger not sold by Andis may result in risk of fire, electric shock,
or injury to person.
15. Do not disassemble charger. Incorrect reassembly may result in a risk of
electric shock or fire. When repair is required, send or take it to an Andis
Authorized Service Station.
16. The battery in this clipper is designed to provide maximum trouble-free life.
However, like all batteries, it will eventually wear out. Do not disassemble
clipper and attempt to replace battery.
17. Batteries can be harmful to the environment if disposed of improperly.
Many communities offer recycling or battery collection. Contact your local
government about disposal practices in your area.
18. When discarding old batteries, cover battery terminals with heavy- duty
adhesive tape to prevent short circuits. wARNiNg: Do not attempt to
destroy or disassemble clipper or remove any of its components. Also,
never touch metal terminals with metal objects and/or body parts, as
short circuit may result. Keep away from children. failure to comply
with these warnings could result in fire or serious injury.
SAvE tHESE iNStRUCtiONS
OpERAtiNg iNStRUCtiONS
Please read the following instructions before using your new Andis clipper. Give it the care that a fine
precision built instrument deserves and it will give you years of service.
• The battery is not intended to be replaced by the user.
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• The battery is to be disposed of safely.
UNivERSAL AC/DC pOwER ADAptER
The unit/charging stand is equipped with a universal AC/DC power adapter. Three interchangeable input
plugs are included for use in most countries around the world (Diagram A).
SAA Plug
Generally used in Australia
REMOviNg iNpUt pLUg:
1. Unplug AC/DC wall adapter from wall outlet.
2. While pressing down on button located on input plug, gently push
up on plug until it releases from wall adapter.
REpLACiNg iNpUt pLUg:
1. To replace input plug, align tabs on the AC/DC wall adapter with
slots on input plug (Diagram B).
2. Gently push input plug into wall adapter until it snaps into place.
Europe Plug
Generally used in Continental Europe
Diagram A
UK Plug
Generally used in Great Britain
Tabs
Slots
Diagram B
3